Temperature and Humidity (HDC1080)

Connection: I2C/Wire
This Block will give the value from the Temperature and Humiditiy. You can choose between the different measurement values in the Dropdown-Menü:

• Temperature
• Humidity

Illuminance/UV-Sensor

Connection: I2C/Wire
This Block I'll be you do the messwert of UV-Licht und Lichtsensor. Im Dropdown-Menü können Sie den jeweiligen Messwert auswählen. Dropdown-Menü:

• Illuminance
• UV-Light

Beschleunigungssensor

Dieser Block gibt den Messwert der Beschleunigungssensoren der direkten auf der SenseBox MCU an. Im Dropdown-Menü können Sie den jeweiligen Messwert auswählen. Dropdown-Menü Richtung:

• x-axis
• y axis
• z-axis
• total

Dropdown measuring range:

• 2g
• 4g
• 8g
• 16g

Fine dust sensor

This block gives you the measured value of thefine dust sensor . In the dropdown menu you can select the respective measured value. Dropdown (measured value):

• PM10
• PM2.5

Dropdown:

• Serial1
• Serial2

Air Pressure/Temperature Sensor (BMP280)

Connection: I2C/Wire
This block gives you the measured value of the air pressure. The air pressure is output by the sensor in Pascal (Pa). If you need the value in Hektopascal (hPa) divide by 100.

Ultrasonic distance sensor

Connection: Digital

This block gives you the reading of the ultrasonic distance sensor. The measured value corresponds to the distance in centimeters. When connecting the sensor, be sure to select the correct pins in the dropdown menu.
Circuit: Ultrasonic distance sensor

Microphone

Connection: analog

This block gives you the reading of the microphone. The output value is a level value between 0 and 5V. When connecting the sensor, be sure to select the correct pins in the dropdown menu. Circuit: Microphone sensor

Button

Connection: Digital

This block gives you the status of the connected button. In the dropdown menu you can select different modes for the button. You can control either the onboard button or a button connected to one of the 6 digital pins. different modes:

• "is pressed": With this mode you can check if the block is currently pressed. You get either TRUE or FALSE.
.
• "was pressed": With this mode you can check if the block was pressed. Only when the button is pressed and released you get TRUE back
• "as switch": If you use this block you can use the button like a light switch. The status will be saved until the button is pressed again

Potentiometer

Connection: analog

This block gives you the reading of the potentiometer. The output value corresponds to a level between 0 and 1023. When connecting the sensor, be sure to select the correct pins in the dropdown menu.

GPS Sensor

This block gives you different measured values of the GPS Sensors. In addition to the longitude and latitude for determining the position, the sensor can also measure the height (in meters) and the current speed (in km/h). Dropdown:

• Latitude
• Longitude
• Height
• Speed